You might think that the air inside your home is much cleaner than outside. But think again and ask yourself when was the last time you have your air ducts cleaned. If you can’t remember anymore or perhaps have never done it, then it’s definitely time that you consider renting a duct cleaning air compressor to help you with the task. In case you don’t know where to start, be guided by the general cleaning steps below.
Step 1. Begin by covering all the supply air registers in your duct system to keep the removed dust and dirt from getting into them and into the rooms while you clean. You can use paper towels or old newspaper to wrap the top of the register.
Step 2. Next is to turn on the “fan only” option on your thermostat. A fan running on while you clean, helps in removing dust along with your brushing and banging. If your thermostat control doesn’t have such option, you can turn on the heat mode.
Step 3. Now is the time to start the dirty work. Loosen buildup dust in the ductwork in your basement by tapping on with the handle of your brush. This will break up dust that may have been deposited inside the duct.
Step 4. Next is to sweep out the dust in the supply registers with the help of a duct cleaning air compressor. Position the end of the vacuum hose near a register and use it to catch the dust. Let the hose go deeper as far as you can reach into the piping while scuffing any loose dust deposits using the brush.
Step 5. Do the same brushing and sweeping in cleaning the return air registers. But you might be required to unscrew the fastener and remove it to access the register piping. Also, go deeper as far as you can reach with the duct cleaning air compressor hose.
Step 6. Now turn off the fan at the thermostat control and the entire power to the furnace in the service switch or panel. This is very critical before you clean the blower compartment as well as the return air boot where the greatest bulk of dust is often found. Sweep up all this dust buildup with the vacuum. You can also follow on cleaning the furnace fan.
Once you’re all done with the cleanup steps above, you can think about replacing your furnace filter if it’s too dirty already or worn. Keep in mind that a dirty filter can affect the airflow and eventually reducing the lifespan of the blower motor. That is all, you deserve a pat on the back for a job well done.
Comments